PCWI Digital Surface
Profile Gauge
PCWI Digital
Metric/Imperial Surface Profile Gauge.
This is a low cost option to surface profile measurement. The
size (57mm diam) of this unit makes it easy to use and easy to balance
on the surface. The special stepped foot and 30deg sharp needle ensures
measurements meet the requirements of Australian Standard 3894.5-2002
(Surface Profile), and as far as we can ascertain it is the only gauge
available which complies with the requirements of this Australia
Standard. Design of the unit permits accuracies equivalent to an
electronic surface trace. Gives maximum peak to average valley height.
This gauge actually works, and works well.
This Gauge works on grit sand shot blasted and saw cut surfaces.
The Digital gauge can also measure, the depth of pits, cracks, craters
and scratches of the outer (in some instances it would do the inside)
surfaces of steel structures, pipes and concrete. Enables quick
assessment of surface condition.
If a hole is made in the coating to the substrate, the gauge will
also function as a coating thickness gauge.
Max Range 0-5mm, pre set to 500µm can be operator changed.
Resolution 0.001mm; Accuracy; ±2µm
Max Range 0.2inch, Resolution 0.00005inch.
Available as metric/imperial.
The reading maximum range is user adjustable.
Used by members of the Australian Corrosion and Pipe Coaters
Association.
Click here Download the product Data Sheet
Click Here to Request
Pricing
|
